To Next PageTo Next Page
Need help?Do you have a question about the Moog D631 Series and is the answer not in the manual?
General| Series | D631 |
|---|---|
| Manufacturer | Moog |
| Category | Control Unit |
| Operating Temperature | -20°C to +70°C (-4°F to +158°F) (typical range, may vary by model) |
| Input Voltage | +24 VDC (typical) |
| Storage Temperature | -40°C to +85°C (-40°F to +185°F) |
Carrying-out work on valves/machines during operation can cause uncontrolled sequences of motions and malfunctions.
General safety advice including falling objects, hot surfaces, noise emission, and skin contact with hydraulic fluid.
Details on the type, viscosity, temperature range, and cleanliness class of hydraulic fluid.
Guidance on storage conditions and protection against contamination and environmental damage.
Information on signal line shielding and connection to reference potential for EMC.
Instructions for starting up the hydraulic system, including pressure setting and venting.
Procedure for adjusting the valve's null position by turning the null adjust screw.
General maintenance is limited to visual inspection and filter changes, no other maintenance is required.
Instructions for replacing the internal filter disk to maintain valve performance.
Information on pilot modes, hydraulic connection schemes, and maximum operating pressures.
Guidelines for electrical safety, SELV/PELV power supplies, and valve phasing.
Compliance with national regulations for disposing of valves, fluids, and packaging materials.
