Page 5 of 6: C70861 Rev A – 01.09
18 Specifications
Function: P, I, or P & I, switch selectable
Input 1: Scaled to 95V max with switch
selectable lag of 55mS.
Input 2: Switch selectable.
4-20mA 240R load, for 0 to +10V on R34.
Or 0 to ±10V direct onto R34.
R34 is plug-in, 100K nominal.
Input 3: R33 plug-in. ±10V gives ±100% valve
drive when R33 = 10k Ohm, ±10% when
R33 = 100k Ohm.
Feedback input: Differential 4-20mA or ±10V, switch
selectable
±15V max.
R in 100k – ±10V
R in 240R – 4-20mA
Feedback amp: Zero, ±10V.
Gain, 1 to 10.
Derivative (velocity) feedback via
plug-in resistor R16 and fixed capacitor.
Transducer excitation: +10V @ 10mA max.
Error amp: Unity gain.
Bias ±1.5V.
Proportional amp gain: 1 to 20.
Integrator gain: 1 to 45 per second.
Integrator input: Switch selectable from output of unity
gain error amp or proportional gain amp
Enable: Relay, +24V @ 8mA, 17 to 32V.
Output amp: Switch selectable voltage or current, single
ended output, return to ground.
V. ±10V, minimum load = 200 Ohm
I. ±5, 10, 20, 30, 50mA to a maximum
of ±100mA
max load =
11V
– 39 Ohm
I (Amp)
Step push button: -50% valve drive disturbance.
Valve supply: Terminal 23, 300mA max.
In position: ±10% of valve drive. 20mA and 40V max
output to PLC.
Front panel Vs, internal supply – green
indicators: Valve drive positive – red
negative – green
Enable – yellow
In position – green
Front panel Valve ±10V (regardless of output
test points: signal selection)
Feedback amplifier output
signal 0V
Front panel Input 1 scale
trimpots: Error amp bias
(15 turns) P gain
I gain
Dither level
Feedback amp gain
Feedback amp zero
()
Dither: 200 Hz fixed frequency.
±10% valve drive. Switch selectable
on/off
Supply: Terminal 1,
24V nominal, 22 to 28V
75mA @ 24V, no valve current,
200mA @ 100mA valve current
±15V output: Terminals 14 and 15,
± (110mA – max valve current)
Wire size range: 0.2mm
2
to 2.5mm
2
(24AWG to 12AWG)
Recommended M205, 250mA T (slow blow) fuse
supply protection: compliant to IEC127-2 sheet 3
Mounting: DIN rail
IP 20
Temperature: 0 to +40ºC
Dimensions: 100W x 108H x 45D
Weight: 180g
CE mark: EN50081.1 emission
EN61000-6-2 immunity
C tick: AS4251.1 emission
19 Internet
www.moog.com/dinmodules
To Next Page
Loading...