Moog Guitar - Page 7

Moo
g
Guitar Service Manual
Example
Install Pick u
p
s:
If not present, place foam cutout into each pickup cavity.
be sure that three holes in foam match the three screw holes in pick up cavity.
Place a pickup in each cavity with its wires passing through the holes joining to the
board cavity. The wires will have to be folded out of the way of the plastic pickup
standoffs.
Tighten six plastic screws until pickups reach their lowest position (this will protect
them from interferin
g
with, or bein
g
dama
g
ed b
y
, the strin
g
s
.
Pre
p
are cavit
y
for board installation:
Place 7 foam pieces in proper locations around board cavity. (see dots in photo for
locations). Place 5 strips of foam in proper locations of cavity bottom. (see
rectangles in photo for locations).