Moo
Guitar Service Manual
Example
Dress wires from breakout boards so they don’t interfere with board installation. Be
especially cautious that wires aren't sandwiched and severed by board. This will
often occur around the switches and
ots.
Install Circuit board: *make sure to use proper static protection when
handlin
board.
Break circuit board out of frame using needle nose pliers to twist break away tabs
Connect four break away boards to main PCB, inside cavity, at correct locations
and correct direction (see photos).
Connect 8 solder points to main PCB (see Fig. D / photo).
Connect piezo saddles in correct order; shortest wire at top and longest wire at
bottom.
To Next Page
Loading...