Moog Infinity Quick Reference Instructions

Innity® is a registered trademark of Zevex, Inc. Moog® is a registered trademark of Moog, Inc.
© 2021 Moog, Inc. Moog Medical, 4314 Zevex Park Lane, Salt Lake City, UT 84123 USA. LS-26015-001 Rev. D
Programming and Running the Pump
These instructions are not a substitute for the operator’s manual.
Be sure to read the operator’s manual thoroughly prior to operating
the pump. See other side for pump operation instructions.
Hang the feeding
container
Hang feeding container so that the bottom of the bag
is at or above the level of the pump door (image A).
Turn on the pump Press and hold the ON/ OFF key for 1.5
seconds to turn the pump on. The display
will show the last programmed rate.
ON/OFF
To program the
rate (how fast
your pump runs)
Press the RATE/DOSE key to display “RATE”
in the lower-left corner of the screen. Use
the + and - keys to program the rate.
RATE/DOSE
To program the
dose (how much
is to be fed)
Press the RATE/DOSE key to display “DOSE” in the
lower-left corner of the screen. Use the + and - keys
to program the dose. Note: If "FEED INTERVAL" is
on the display, clear feeding interval by pressing
the FEED INT key, then press the CLEAR key.
RATE/DOSE
FEED INT CLEAR
To program
a continuous
feeding (rate
only setting)
If "FEED INTERVAL" is on the display, clear feeding
interval by pressing the FEED INT key, then press
the CLEAR key. Press the RATE/DOSE key twice to
display “DOSE” in the lower-left corner of the screen,
and hold the + key until the displays reads INF.
FEED INT CLEAR
RATE/DOSE RATE/DOSE
To program an
interval feeding
(or intermittent
feeding)
Press the RATE/DOSE key to display "DOSE" in the
lower-left corner of the screen. Use the + and - keys
to program the dose. Press the FEED INT key to
display "FEED INTERVAL" in the lower-left corner
of the screen. Program the desired number of
hours and minutes using the + and - keys.
RATE/DOSE
FEED INT
Start the pump Press the RUN/PAUSE key to start the pump.
RUN/PAUSE
When feeding
is complete
When feeding is complete, press the ON/OFF
key for 1.5 seconds to turn the pump o.
ON/OFF
To clear settings Press the CLEAR key to reset the displayed
value. Press and hold the CLEAR key for 3
seconds to reset rate, dose, feed interval, and
volume delivered values at the same time.
CLEAR
View volume
delivered
Press the VOL/TOTAL key once to display volume
delivered for the current feeding. Press the key
again to display the total cumulative volume
delivered since the total volume was last reset.
VOL/TOTAL
A

Moog Infinity Specifications

General

Model	Infinity
Type	Infusion Pump
Occlusion Pressure Settings	Low, Medium, High
Alarms	Occlusion, Low battery
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to 60°C
Manufacturer	Moog
Infusion Modes	Continuous, Intermittent
Display	LCD
Compatibility	Standard infusion sets