on its own IR light source. The Battery Indicator will
reflect the charging status.
Several tasks can only be performed when Scout is in
the charging station, including software OTA (over-
the-air) update, monitoring with motion detect, and
reboot.
Avoid heat sources or other battery-unfriendly
conditions to place the Charging Station.
6. Powering Scout On & Off
Press the “On & OFF” button for 2 seconds until the
Power LED lights up. The system will boot up. Press and
hold the button for 3 seconds to turn it off.
When Scout is turned off and is placed in the charging
station, the bot will automatically boot up.
Important note:
Features that require Scout to boot up, such as OTA
(Over-the-Air) update and Reset-to-Factory condition, are
better to have the bot in the charging station. Otherwise, users
must manually power up the bot again.
To Next Page
Loading...
