Boiling Point Detection Memory Function
How to Clean
Scale Removal
Note: The boiling point memory function is set for use in high altitudes, and it is not
necessary to use in normal life.
（1）Put cold water into the pot and put it on the base (do not plug in at the moment).
Press the "Keep Warm" button first and then plug in the power.
（2）Release the button immediately after hearing a prompt beep. At this time, the
screen displays "H1" and the "Start/Stop" button blinks.
（3）Press the "Start/Stop" button to start the test (heating), the screen continues to
display "H1", the test process lasts until the water boils and turn off. After the test
is completed, the system records the boiling point data, and has three beeps, and
then enters the standby state.
（4）Boiling point temperature reset: first press the "Keep Warm" button (needn't put
the pot on the base), and then plugged in, about 1 second later "H1" shows ,
continue to hold the "Keep Warm" button, about 2 seconds later "H0" shows, the
"Start/Stop" button lights flashing, press the "Start/Stop" button, hear 3 beeps,
boiling point reset is then complete. The boiling point was restored to factory setting.
◇. Unplug the kettle and let it cool.
Note: Do not immerse the kettle, power cord or plug in water！
◇. Allow to clean the surface of the kettle, you can use a cloth of slightly wet water
wipe, do not add any additives.
◇. Do not use a sander, which can damage the surface of the product and may cause
electric shock.
◇. The kettle should be thoroughly dried after cleaning and kept dry.
Note: Long-term use will have mineral precipition, this is not a produuct
quality problem.
◇. Hard water can allow minerals to build up inside the kettle. To avoid this, use
drinking water.
◇. Any conventional scale remover can be used whenever directed to remove all
residues completely.
◇. Fill the kettle with water and bring it to a boil. Do several cycles to flush the kettle.
Don't fill it so full that it doesn't splash out when it boils.
8
To Next Page
Loading...