Why does no water come out of my Mora MMIX Tronic?
If no water is coming out of your Mora Plumbing Product when activated, several factors could be at play. First, the supply voltage might be too low, so check the battery/voltage. Alternatively, the inlet screens might be blocked, requiring cleaning. Lastly, a defective or blocked solenoid valve could be the culprit, necessitating replacement.
What to do if my Mora MMIX Tronic tap does not turn off?
If your Mora Plumbing Product tap isn't turning off, it might be in hygiene flush mode. In this case, wait three to thirty minutes or briefly switch off the power. (A yellow LED flashes in flush mode). Another possibility is a faulty solenoid valve, which would need replacing. Finally, the flush time may be set too high; wait up to thirty seconds or briefly switch off the power and reset the sensor.
Why is the sensor flashing on my Mora MMIX Tronic Plumbing Product?
If the sensor on your Mora Plumbing Product is flashing, it indicates that the supply voltage is too low. You should check the battery/voltage.
How to fix high or low pressure in my Mora MMIX Tronic Plumbing Product?
If you're experiencing pressure issues with your Mora Plumbing Product, where the pressure is either too high or too low, it could be due to a blocked aerator. Try cleaning the aerator. Another potential cause is blocked filters (inlet/solenoid valve). You should clean the inlet screens and replace the solenoid valve if necessary.
What to do if my Mora Plumbing Product starts running on its own?
If your Mora Plumbing Product tap starts running without being turned on, the hygiene flush mode may be activated. A yellow LED flashes in hygiene flush mode. To resolve this, change the program to 1–3.
Why is my Mora MMIX Tronic Plumbing Product tap dripping?
If your Mora Plumbing Product tap is dripping, it is most likely due to a leaking solenoid valve, which will need to be replaced.
What to do if the programme on my Mora MMIX Tronic Plumbing Product can not be changed?
If the program on your Mora Plumbing Product cannot be changed, it might be locked by the remote control. Program seven is activated. Use the remote control to change the program. Alternatively, the tap needs to be activated immediately before programming, so activate it by hand before programming.
General installation guidelines for licensed plumbing companies.
Installation of external power supply according to local regulations.
Recommendations for protecting the mixer from frost damage.
General| Material | Brass |
|---|---|
| Finish | Chrome |
| Mounting | Deck Mounted |
| Power Supply | Battery or Mains |
| Maximum Pressure | 10 bar |
| Protection Class | IP 44 |
| Control Type | Electronic |
To Next Page
