To Next PageTo Next PageWhy does no water come out of my Mora MMIX Tronic?
If no water is coming out of your Mora Plumbing Product when activated, several factors could be at play. First, the supply voltage might be too low, so check the battery/voltage. Alternatively, the inlet screens might be blocked, requiring cleaning. Lastly, a defective or blocked solenoid valve could be the culprit, necessitating replacement.
What to do if my Mora MMIX Tronic tap does not turn off?
If your Mora Plumbing Product tap isn't turning off, it might be in hygiene flush mode. In this case, wait three to thirty minutes or briefly switch off the power. (A yellow LED flashes in flush mode). Another possibility is a faulty solenoid valve, which would need replacing. Finally, the flush time may be set too high; wait up to thirty seconds or briefly switch off the power and reset the sensor.
Why is the sensor flashing on my Mora MMIX Tronic Plumbing Product?
If the sensor on your Mora Plumbing Product is flashing, it indicates that the supply voltage is too low. You should check the battery/voltage.
How to fix high or low pressure in my Mora MMIX Tronic Plumbing Product?
If you're experiencing pressure issues with your Mora Plumbing Product, where the pressure is either too high or too low, it could be due to a blocked aerator. Try cleaning the aerator. Another potential cause is blocked filters (inlet/solenoid valve). You should clean the inlet screens and replace the solenoid valve if necessary.
General| Material | Brass |
|---|---|
| Finish | Chrome |
| Mounting | Deck Mounted |
| Power Supply | Battery or Mains |
| Maximum Pressure | 10 bar |
| Protection Class | IP 44 |
| Control Type | Electronic |
