21
increases the height. The adjustment is correct when the
body of the flame is about 3 to 4 mm high.
Replace the knob and set it to the switch off position, then
replace the oven base.
If the flame sensor does not operate properly, check its
position according to fig.
Flame sensor position
1 - Flame sensor
2 - Oven burner
1 -
2 -
:
1 -
2 -
CONVERSION TO ANOTHER TYPE OF
GAS
Conversion of cooker to another type of gas can be
performed only by qualified technician.
Adhere to the following procedure:
Change nozzles of all burners.
Adjust or change gas pressure regulator if installed.
Adjust oven burner primary air.
Adjust SAVING power position of hob burners.
Stick new gas setting label with relevant nozzle
information.
To conduct this operation, make the appropriate
entry in "The warranty card."
ғ
ұ
(ғ ),
„
“,
, ,
(
),
,
,
“ ”ғ
ғ
:
( ),
« »
,
,
, (
),
,
To Next Page
Loading...