8
1 - OFF
2 - MAXIMUM POWER
3 - MINIMUM POWER (SAVING)
1 -
2 -
3 - ( )
1 -
2 -
3 - ( )
The gas supply to the oven burner is controlled by a tap
protected with a thermoelectric flame sensor.
The power input of the oven burner as well as the
temperature of the oven space can be controlled by
ЬОЭЭТЧР ЭСО kЧШЛ ЭШ ЭСО ЩШЬТЭТШЧЬ „MAБIMUM POАER“
КЧН „SAVING“
ғ
,
,
“
” ” ”ғ
ғ
,
« »
« »
ғ
IGNITION OF THE OVEN BURNER
Open the oven door.
Set the oven burner control knob to the position
"MAXIMUM" and press it slightly towards the panel
to a limit position. At the same time hold a match at
an opening in the oven bottom.
After firing the burner hold the knob pressed to a limit
position to the panel for about 5 seconds till the
flame sensor heats up.
Release the knob and check whether the burner is
on. If the flame dies after releasing the knob, repeat
the ignition procedure. After that set the knob to the
desired position.
ғ
“ ”
ғ
ғ
, /
,
, 5 ,
ғ
,
ғ ,
ғ
.
« »
,
ғ
ғ
, /
5 ,
,
ғ
,
ғ ,
ғ
IMPORTANT:
If the burner is not on after 10 seconds, open the oven
door and wait for 5 minutes before the next try.
!
Қ0 ,
5 ,
ғ
!
Қ0 ,
,
5 ғ
To Next Page
Loading...