Hotplate, burner caps, pan supports.
Cloth wrung out in hot soapy water. Stubborn stains.can be
removed with a cream paste approved by the Vitreous Enamel
Development Council, liquid cleaner or by rubbing with ne steel
wool soap pads.
NOTE: The pan supports can also be cleaned in the dishwasher.
Hotplate burner bodies.
Similar to paint cleaning above. Use a nylon brush to remove
any cleaning materials, water or dirt from the hotplate burner
bodies. After cleaning, wipe dry and ret to the hob ensuring they
are correctly seated. Check parts are reassembled correctly by
lighting the burners and allowing to dry out.
Control knobs.
Wipe with a cloth wrung out in hot soapy water.
Cloth wrung out in hot soapy water.
VITREOUS ENAMEL
ALUMINIUM
PLASTIC
STAINLESS STEEL
Cleaning
Safety instructions
Ensure that these notes and that the whole of this instruction
book are thoroughly read and understood before installation or
operation of the hob.
The instructions are provided in the interest of your safety.
1. It is the law that all gas appliances are installed by competent
persons in accordance with current edition of the above
regulations. It is In your interest and that of safety to ensure
compliance with the law.
2. Repairs or servicing of this product must only be carried out
by an authorised agent service agent service agent using only
approved parts.
3. No attempt must be made to modify this appliance.
4. Cooking appliances become very hot in use, therefore ensure
children and pets are kept away. The use of oven gloves is
recommended when during use,
5. Do not allow children to operate or play with any part of the
appliance.
GAS SAFETY
(INSTALLATION & USE)
REGULATIONS
3
To Next Page
Loading...
