Congratulations on purchasing your new Morgan
Amp!
Joe Morgan started designing amplifiers to create
solutions to the problems he was facing as a
guitarist.
Joe Designed the AC20 to be reminiscent of the
best of the early 60s class A British amplifiers.
Don’t let the simple control panel fool you, there
is an amazing palate of tones to choose from.
The AC20 takes pedals very well and loves Fuzzes,
boosts, OD’s, phasers, flangers, tremolos, wahs,
and all types of delay pedals. This amp was
designed to interface with all of your pedals
modern or vintage.
• Incredibly versatile single channel amp
• ¼ - 20-watt 2X EL84 Power Tubes
• 2x 12ax7s
• Solid state rectifier
• Power level control ¼ - 20W
• Cut control
• Bass cut switch
• Bright switch
• Custom transformers and capacitors.
• Volume control
PLUGGING IN
One of the best features of the AC20 is that you
can’t get a bad sound out of it.
We recommend that you start with the power
scaling all of the way up and the volume all of the
way down. Cut control set to 12 o’clock and the
switches set to the down or “normal” position.
From here you can gradually bring up the volume
until you reach the desired level of gain. Once you
have this set you can change the Power Level
control to achieve the level of volume you require.
Now that you have your gain and volume set
experiment with the bass and treble, and bright
switches. Increasing the cut control clockwise will
add high frequencies to your signal.
We know you will love your new AC20. If you have
any questions or help don’t hesitate to email us at
info@morganamps.com.
To Next Page
Loading...