Morphy Richards 403040 - Initial Setup and Preparation; Before First Use Instructions; Manual Blending Operation Guide

6
4
Plug the Total Control Table Blender into the
mains socket & switch on (16).
3
Place the Lid (2) on the Plastic Jug (5),
pushing down firmly. Place the Measuring
Cup (1) into place twisting clockwise to lock
into place. To avoid spillages ensure the
pouring hole in the Lid (2) is turned away from
the Spout (4).
2
Place the food or cold liquids into the
Plastic Jug (5). Do not exceed more than the
recommended amount (see page 11).
1
Place the Plastic Jug (5) onto the
Base Unit (7).
• Carefully unpack your Table Blender as the
B
lending Blades are very sharp.
• Remove any stickers (except for the serial label
o
n the base of the product).
• C
arefully wash the Jug, Lid and Measuring Cup
in hot soapy water. Rinse and dry.
• W
ipe over the Base Unit with a damp cloth.
• WARNING: Never immerse the Base Unit in
w
ater or in any other liquid. Always ensure the
electrical connections are kept dry. This may be
w
iped with a clean, damp cloth.
Before First Use
Using Your Total Control Table
Blender - Manual Control
FP403040 REV 2.qxp_Layout 1 25/01/2019 11:48 Page 6