Features
(1) Bread Slots
(2) Bread Carriage Levers
(3) Browning Control
(4) Cable Storage (underneath)
(5) Cancel Button
(6) Re-heat Button
(7) Frozen Button
(8) Crumb Tray (at rear)
Before first use
• Before using your toaster for the first time, operate the toaster
without bread.
• As with all new electric heating elements, your toaster will emit a
‘new’ smell when it is first switched on. This is quite normal and
not a cause for concern.
Using your toaster
1
Place the sliced bread into the Bread Slots (1).
2
Adjust the Browning Control(s) (3) to the
desired setting and plug your toaster into the mains.
3
Lower the Bread Carriage Lever(s) (2). The toaster will begin
toasting the bread.
4
When completed, the Bread Carriage Lever(s) will automatically
rise and lift the toast from the toaster.
Additional features
Cancel Button (5)
If you wish to stop the toasting process, press the Cancel Button
(5).
Re-heat Button (6)
If your toast has popped up and gone cold, the toaster offers a
re-heat facility. To use, lower the Bread Carriage Levers (2), and
press the Re-heat Button (6) immediately. The button will illuminate
and the toaster will operate for a short period reheating the bread.
Frozen Button (7)
To toast frozen bread, do not adjust the Browning Controls (3)
from your normal setting. Place the frozen bread in the Bread
Slots (1), lower the Bread Carriage Lever (2) and press the Frozen
Button (7). The button will illuminate and the toaster will operate
for a longer period defrosting and toasting the bread.
Removing the Crumb Tray
5
Crumb Trays (8) and could catch fire if not emptied regularly.
1. When the appliance has cooled down completely, tap the sides of
the case lightly to dislodge any crumbs lodged in the Bread Slots
(1).
2. Pull the Crumb Trays to unlock and remove from the toaster.
3. Empty the Crumb Trays and replace, push to lock back into place.
Never operate the appliance without the Crumb
Hints and tips
• In order to achieve uniform browning, we
recommend you wait a minimum of 30 seconds between each
toasting cycle, so that the control can be automatically reset.
• If toasting one slice only, you may need to adjust the Browning
Control (3) to a slightly lower setting. You will notice a variation in
toast colour on one side of a single slice. The side facing the
outside wall of the Bread Slot (1) will be darker in colour than the
side facing the inner wall of the bread slot.
• When toasting 2 slices it is recommended they are of equal size
and freshness.
• Stale bread toasts more rapidly than fresh bread. Therefore, the
Browning Controls should be set at a lower setting than usual.
• All sorts of bread can be used as well as teacakes, small rolls etc.
Slices should not however be so thick as to cause burning or
jamming within the Bread Slots (1).
• If the bread in your toaster becomes jammed disconnect your
toaster at the socket, allow it to cool, then remove the bread.
• Allow the toaster to cool fully before putting away.
• Should some toast remain blocked in the toaster, remove the plug
from the mains, wait for the toaster to cool down until it is safe to
touch, then turn the toaster over and shake it gently.
Care and cleaning
• Before cleaning, unplug your toaster and let it cool down.
• The external part of the appliance must be cleaned with a soft
cloth. Do not use abrasive detergents that can ruin the surface.
• DO NOT IMMERSE IN WATER.
• After each use, remove the plug from the electrical outlet and
empty the crumb collection tray that is under the appliance.
DO NOT TOUCH ANY PART OF THE TOASTER WITH SHARP
OR METAL UTENSILS, ESPECIALLY INSIDE THE BREAD
TOASTING SLOTS. RISK OF ELECTRIC SHOCK AND DAMAGE
TO THE TOASTER.
6
TT240101MAUS Rev 1.qxp_Morphy Richards Instruction Book 27/09/2017 16:15 Page 6
To Next Page
Loading...
Need help?
General
