www.morphyrichards.com
6
UK Helpline 0844 871 0953 Replacement Parts 0844 873 0719 Ireland Helpline 1800 409 119
Dry ironing
1 Connect the appliance to a
suitable mains outlet.
2 Press the power switch 3 times
until all three steam level
indicators go off (steam off
mode).
3 Turn the temperature dial on the
iron in a clockwise direction,
select dot-1, dot-2, or dot-3
according to the
recommendation of the garment
label.
4 The temperature indicator light
glows on the iron, indicating that
it is switched on.
5 When the required temperature
is reached, the temperature
indicator light on the iron goes
off. The iron is ready to use.
It is always a good idea to begin
with ‘cool’ fabrics and work up
to higher settings.
An iron heats up quicker than it
cools down so you’ll save time
and electricity.
Auto-shut off
An auto-shut off system will
activate if the steam is not used
for over 15 minutes. The mode
indicator light „ will flash
between green and red,
indicating the unit is in ‘sleep
mode’.
When this occurs, press the
steam trigger ⁄ or the power
switch ‚ once. The appliance
will switch on immediately and
you need to select the required
setting.
ANTI-SCALE SYSTEM
The anti-scale cartridge is
designed to reduce the build-up
of limescale which occurs
during steam ironing. This will
prolong the working life of your
iron. However, please note that
the anti-scale cartridge will not
completely stop the natural
process of limescale build-up.
Replacing anti-scale
medium
How often you need to replace
the medium depends on how
often you use your iron with its
steam functions and how ‘hard’
your water supply is. Water
hardness varies greatly from one
area to another. For advice on
the relative hardness of your
water, contact your local water
supplier.
If, on average, you spend 2
hours per week ironing, then we
suggest you replace your
anti-scale medium as shown in
the table below. If you iron more
or less frequently, then you
should alter the interval between
refills accordingly.
Replacement
anti-scale refills
To obtain replacement anti-scale
refills, telephone our spares
number on: 0844 873 0719.
• If a new re-fill is not available,
you may continue operating the
appliance but scale will build up
in the system. Replace the anti-
scale refill as soon as possible.
1 Disconnect the appliance from
the mains outlet.
2 Slide out the tank and remove
the antiscale cartridge E.
3 Pull the plate from the end of
the cartridge F.
4 Remove the foam pad G and
slide out the spent antiscale
sleeve H.
5 Place the refill into the cartridge,
reposition the foam pad and clip
the plate onto the cartridge,
making sure it locks in position.
6 After changing the anti-scale
cartridge, press the anti-scale
button once before replacing the
water tank I.
Water
hardness
Soft Medium Hard
Refill interval
(months)
6 3 1
1
/2
E
I
F
G
H
To Next Page
