Installation
1．Clean the Measuring cup, Lid and Blending glass cup (except main body) and so on
before first use.
2．So as to make sure the unit is turned off, do not connect it before installation.
3． First install the Glass jar sealed ring into blade base, then enclose the blade base into
Blending glass jar and finally screw the jar holder on the base of the glass jar.
4．Now you can place the entire glass jar on the top of the main body of the motor. Please
pay attention to match the position of blending glass cup and the bulge of the motor main
body.
Fill the blending receptacle with the desired food. Please ensure the water is not spilled
over from cup.( Maximal water capacity can not exceed 1700 ml). DO NOT USE THE
UNIT WITHOUT ANY MATERIAL INSIDE.
5．Put the lid on top of the blending glass cup and push it down. Insert the closure into the
lid and turn till it locks into place.
6. Place the measuring cup on the center of the lid; turn the measuring cup slightly
anticlockwise.
OPERATION
1． Connect to the power. Please ensure the rotating switch is turned to “OFF” before
connecting the power.
2． This unit has safety design features, it will not work if the blending glass jar is not
installed properly on the main body of the motor.
3． Fill the glass jar with the desired food.
4. Put the jar cover on top of the blending glass jar and fix it. Place the measuring cup on
the center of the jar cover, turn the measuring cup slightly anticlockwise.
5．Put the glass jar on the upper base of the main body. The blue light of Aureole means
that power is connected.
6. If you want to use the grinder, open the grinder jar, then put the coffee beans into the
grinder jar. The coffee bean cubage should be less than 60% of the total grinder cubage.
It is better this way. Fit and tighten on the grinder jar the grinder’s jar sealed ring, the blade
components and finally the grinder’s jar holder . Then, put the whole grinder into the upper
holder of the housing. You can start blending coffee beans.
To Next Page
Loading...