Morris T71360CAP - Cleaning the Water Tank

EN
23
THE VARIOUS FUNCTION AND POSSIBILITIES
To serve your drink press valve lever slightly.
Filing the water tank
• Remove the top cover of the water tank.
• Fill up the tank with water.
• Mount back the top cover of the water tank.
Attention
• Do not use the water dispenser anything except water.
• If you leave water in the tank for a long time it could cause odour.
In this case clean the tank and keep using it.
• Clean up the water tank before using it for the rst time.
Cleaning the Water Tank
• Lift the water tank.
• Remove the tank cover with upholding the side locking covers.
• Clean up the tank with warm water and reassemble the pieces
you removed.
Stowing the Water Tank
• Install the water tank as shown.
• Be careful about the tap and the hole match each other while
installing.
• Water ow can appear unwillingly if the tank have not taken its
place properly. Also check the gaskets are assembled properly.
Drip Tray
• Please pay attention in order not to go down min level on the tank
surface. During the usage of dispenser the water can be splash
after min water level.
ATTENTION:
PLEASE HOLD THE GLASS FOR ONE SECOND LONGER
AFTER DISTRIBUTION TO AVOID DRIPS.