To Next PageTo Next Page
Need help?Do you have a question about the MORryde EASY REEL and is the answer not in the manual?
Install the spooler by screwing into the 8 mounting holes. It can be mounted with the motor on either side.
Connect to a 12V power source, ensuring a 10-amp fuse. Connect red wire to (+) and black wire to (-).
Mounting affects switch direction for reeling. Push switch to reel cord in/out. Store cord using handle, guiding side-to-side.
Unreel by pushing the switch and keeping it pressed in the opposite direction used for reeling.
Check for the overload reset button under the switch and press it to reset.
Verify that 12V power is being supplied from the power source.
Remove the motor cover to check for loose connections between the motor, switch, or reset switch.
Install the spooler by screwing into the 8 mounting holes. It can be mounted with the motor on either side.
Connect to a 12V power source, ensuring a 10-amp fuse. Connect red wire to (+) and black wire to (-).
Mounting affects switch direction for reeling. Push switch to reel cord in/out. Store cord using handle, guiding side-to-side.
Unreel by pushing the switch and keeping it pressed in the opposite direction used for reeling.
Check for the overload reset button under the switch and press it to reset.
Verify that 12V power is being supplied from the power source.
Remove the motor cover to check for loose connections between the motor, switch, or reset switch.
General| Brand | MORryde |
|---|---|
| Model | EASY REEL |
| Category | Racks & Stands |
| Language | English |
