Morso 2110 - Page 3

3
1.1 Before installation
Make sure that the ue you intend to use is well constructed, well insulated and well swept.
Your Morsø dealer will be able to advise you about the suitability of your existing ue system
and can even arrange for a custom-built ue to be installed if you do not have one already.
The installation must conform with the relevant national and local building regulations. Again,
your Morsø dealer will be able to help you with this.
Stove parts
Your Panther should arrive complete with the following parts:
- Six inch ue collar with xing lugs
- Flue blanking plate, xed in position on the top plate
- Stainless steel ash pan
- A tool used for both riddling and ash pan handling
- Spare sealing rope
- Poker
- Door handle
If any of these parts are found to be missing, please contact your Morsø dealer.
Key
1. Bae plate
2. Ash pan
3. Flue collar
4. Blanking plate
5. Riddling grate
6. Air valves
7. Log retaining bar
Cast iron
Cast iron is a live material. There are no
two ovens that are identical. This is partly
due to the tolerances of the casting pro-
cess, partly because the ovens are a work
of craftsmanship.
Minor unevennesses may also occur in the
cast iron surface.
1.0 Directions for installation