Installation of woodburning stoves must be safe and legal.
If your Morsø stove is not installed correctly, it may cause a house re. To reduce the risk
of re, the installation instructions must be followed carefully. Contact the local building
ocials about restrictions and installation inspection in your area.
Before you start installing your stove, make sure that:
- The stove and chimney connection are placed far enough from combustible materials to
meet all clearance requirements.
- The oor protection must be adequate and must be made correctly according to ´the
requirements.
All neccessary approvals are needed from the local building ocials.
The data plate, which is located on the back of the stove, provides information regarding
safety testing information, name of certied testing laboratory, and installation require-
ments.
Installation requirements vary in dierent districts, and the local building ocials have
the nal authorization to approve your installation. You should discuss the installation
with them before beginning. Please ask your dealer for further information.
Do not connect to any air distribution duct or system.
Important: If the installation instructions are not followed carefully, it may cause dan-
gerous situations like chimney - and house res. Follow the instructions carefully and
do not deviate from them as it may cause injuries to people or property.
1.1 Unpacking the stove
After removing the outer packaging place it gently on its back. The cardboard packaging can
be placed underneath to prevent marring. Remove the leg pack from the stove and bolt each
leg/panel securely to the underside of the base on the combustion chamber, using the bolts
provided (found inside the stove).
We recommend that two people perform the assembly and installation procedure.
The Morsø 2110 weighs 125 kg.).
1.2 Checking loose parts in the stove
After unpacking, check that the re bricks are rmly in position and have not shifted in tran-
sit. Check also that the air control works freely.
Standard Accessories
Poker, ceramic ue connection gasket and ash can tools are standard accessories, and can
usually be found in the ashpan or rebox area.
1.0 Installation of your Morsø stove
To Next Page
Loading...
