Morso Model F - Page 39

MASKINFA8RIK
HARALDSVEJ 21
DK-8900 RANDERS
TLF. + 45864351 55
FAX. -t- 45 86 43 51 00
Instructions manual
MORS0 Mitring machine
Model F + H
Accessories
L-1-2
®
picture L-1-2-1
pet
picture L-1-2-2
MORS0
22
Beware of the extreme
sharp knives
MORS0 F+H -9503 L-1-2/gb1
40
REBATE SUPPORT ATTACHMENT, AUTOM.
Installation Instructions
Install the attachment on the left side first.
1. The knife block unit must be in the rear
position and locked in bottom position.
The knife block unit must under no cir-
cumstances be moved during the instal-
lation.
2. Remove the screws (1) from the short
guide rail (2).
The screws (1) are replaced by screws (5).
3. Place the bushing (3) in the borings on the
short guide rail (2).
4. Install the the bottom part (4) on the
short guide rail (2) with the screws (5).
5. The screws (5) are screwed in so that
there is a distance of about 0.1 mm
between the slide frame and the short
guide rail (2).
6. The bottom part is now installed on the
right side.
7. Drill the holes (6) in the slide frame
according to the enclosed template (depth
of hole about 15 mm)
OBS: On machines delivered after
1995.02.01 the holes are already drilled.
8. Fasten the top plate (7) with screws (8).
9. Dismount screw (9) in the rebate support
and put in bushing (10).
10. Install the draw bar (11) with the screw
(12) - the draw bar holder must slide in
the slot on both the top plate (7) and the
bottom part (4).
11. Place the slide bar (13) between the top
plate (7) and the bottom part (4).
12. Install the washer (14) with the screw
(15).