Why does my Mortara Quinton CR60 belt stop and show an over-current error code?
Stopping the Mortara Treadmill belt for more than 2 seconds when it is set to ON can cause an over-current shutdown. To resolve this, avoid stopping the belt for longer than 2 seconds. Additionally, consider turning over or replacing the deck and belt.
How to fix squealing sound on Mortara Quinton CR60 Treadmill?
If your Mortara Treadmill is making a squealing sound similar to a loose automobile fan belt, the drive belt might be loose. Try adjusting the belt tension, and if the squealing persists, replace the belt.
What to do if my Mortara Quinton CR60 shows error E203?
Error E203 on your Mortara Treadmill indicates a motor overload. This can be due to several reasons: 1. The runner being heavier than the weight/speed specifications. 2. Deck wear. 3. A disconnected or loose motor lead. 4. An electrical short on the board near the power electronics. 5. Power electronic component failure. 6. The motor being blocked by an obstruction. To resolve this: 1. Restrict use to people within the weight/speed specifications. 2. Check the deck wear and replace it if necessary. 3. Ensure all motor leads are connected properly. 4. Examine the board for shorts, blackened components, or discoloration. Replace the board if damaged. 5. Remove any obstructions.
How to fix squealing sound similar to automobile fan belt on Mortara Treadmill when user’s foot strikes the deck?
If your Mortara Treadmill is making a squealing sound similar to an automobile fan belt and the walk belt slows down when the user’s foot strikes the deck, the drive motor belt (poly-V drive belt) is likely slipping. To fix this, adjust the belt tension or replace the belt.
What causes knocking or thumping in Mortara Treadmill?
Knocking or thumping sounds in your Mortara Treadmill, with the rate increasing and decreasing with walking belt speed, are likely due to the front or rear roller (pulley) assembly bearings. To resolve this, isolate and replace the affected roller.
What to do if Mortara Quinton CR60 shows error E105?
To address error E105 on your Mortara Treadmill: 1. Press Stop, Faster, and Slower to enter Service Mode. 2. Press Stop and Cool Down to reinitialize NVRAM. 3. Press Clear. 4. Reconfigure the controller. If the error persists, replace the controller.
How to fix popping during grade change on Mortara Treadmill?
If you hear popping sounds during grade changes on your Mortara Treadmill, it is likely due to faulty elevation chain alignment. Adjust the alignment of the sprockets to resolve this issue.
How to troubleshoot Mortara Quinton CR60 Treadmill error E201?
To troubleshoot error E201 on your Mortara Treadmill: 1. Enter service mode. 2. Calibrate POT. 3. If the error persists, replace POT. 4. If the error continues, replace the AC Drive Module.
What to do if Mortara Quinton CR60 shows error E101?
To resolve error E101 on your Mortara Treadmill, replace the controller.
What to do if Mortara Quinton CR60 shows error E102?
To fix error E102 on your Mortara Treadmill, replace the controller.
General| Running Surface | 20 in x 60 in (51 cm x 152 cm) |
|---|---|
| Weight Capacity | 400 lbs (181 kg) |
| Dimensions | 83 in L x 34 in W x 56 in H (211 cm L x 86 cm W x 142 cm H) |
| Display | LCD |
| Motor | 3.0 HP continuous duty |
| Emergency Stop | Yes |
| Programs | Multiple pre-programmed exercise protocols |
To Next Page
