Need help?Do you have a question about the Motak PKM0335 and is the answer not in the manual?
Describes the ice making process for PKM models.
Details the non-adjustable timers on the control board.
Explains safety limits and indicators for PKM models.
Procedures for checking PKM model operation.
Procedure to check and adjust ice thickness for PKM models.
Describes the ice making process for PKU model.
Details the freeze cycle of the ice making process.
Details the harvest cycle of the ice making process.
Explains the automatic shut-off mechanism.
Explains safety limits and indicators for PKU models.
Procedures for checking PKU model operation.
Explains the siphon system for PKU models.
Checks for proper water level in the PKU model.
Detailed steps to check water level in PKU models.
Procedure to check and adjust ice thickness for PKU models.
Specifies ice weight specifications per cycle.
General guidelines for ice machine maintenance.
Step-by-step guide for thorough descaling and sanitizing.
Procedure for descaling without full disassembly.
Guidelines for cleaning the exterior of the ice machine.
Checks for leaks and tubing condition.
Instructions for removing the door on PKM models.
Steps for sanitizing the ice machine components.
Detailed steps for removing parts on PKM models.
Detailed steps for removing parts on PKU models.
Procedure for descaling without full disassembly.
Instructions for cleaning the washable condenser filter.
Procedure for cleaning the condenser fins.
Steps for preparing the machine for removal or winter.
Guide to diagnose and correct common ice machine problems.
Explanation of built-in safety limits and restart procedures.
Lists all supported ice machine models and bins.
Requirement for ice deflector when installing ice machine on dispenser.
Steps for installing the ice storage bin.
Criteria for selecting the proper installation location.
Specifies necessary clearances around the ice machine.
Details heat rejection values for different ice machine models.
Detailed steps for installing the ice storage bin.
Recommendations for installing the ice machine with a dispenser.
Explanation of the air gap for back-flow prevention.
General guidelines for electrical connections and safety.
Information and recommendation regarding GFCI protection.
Guidelines for power cord sizing and length.
Chart detailing breaker sizes and amperage requirements.
Requirements for water supply and drain connections.
Guidelines for installing water inlet lines.
Follows guidelines for installing drain lines.
Procedure for installing the auxiliary base drain.
Table detailing water/drain line sizing.
A checklist for ensuring proper installation.
Steps to follow before operating the ice machine.
Guidance on adjusting ice thickness for weight.
To Next Page
General