Need help?Do you have a question about the Motak PKU0155 and is the answer not in the manual?
Explains DANGER, WARNING, Caution, Notice, and Important symbols used in the manual.
Key recommendations for safe operation, maintenance, and environmental considerations.
Specific warnings for installation personnel and end users regarding safe operation and handling.
Crucial safety warnings covering misuse, electrical hazards, flammables, and personal protection.
Lists supported models and provides guidance for ice deflector and bin installation.
Specifies ideal location criteria, required clearances, and the machine's heat output.
Details for installing the ice machine on a bin or dispenser, including air gap requirements.
Guidelines for electrical connections, circuit protection, grounding, and power cord specifications.
Instructions for water supply, inlet lines, drain connections, and line sizing for optimal performance.
A comprehensive list of checks before starting the machine and essential pre-operation steps.
Describes the sequence, control board timers, and operational checks for PKM ice machines.
Procedure for inspecting and adjusting the ice thickness for PKM models to ensure proper ice bridges.
Explains the sequence, automatic shut-off, safety limits, and operational checks for PKU ice machines.
Guides for checking water level, siphon action, and adjusting ice thickness for PKU models.
Details minimum and maximum ice weights per cycle for various models to meet production targets.
Recommendations for routine descaling and sanitizing every six months for efficient operation.
Step-by-step instructions for thorough cleaning of the ice machine's evaporator and bin components.
A procedure for descaling components in the water flow path between main cleaning intervals.
Guides for cleaning the condenser filter, condenser fins, and preparing for removal from service.
A guide to diagnose and correct common operational problems before contacting service personnel.
Addresses issues like incorrect cycling, poor ice quality, and incomplete cube formation in the machine.
Solutions for low ice production and understanding how to interpret and reset safety limit shutdowns.
To Next Page
General