MOTECK CB4M-S - User Manual

@
@
User Guide
MOTORIZE OUR WORLD
R


CB4M-S Quad Synchronous Control Box
Model:CB4M-S & DKP3
Model Name：
CB4M-S: Quad synchronous control box
DKP3: Desk control panel
Product Introduction：
The set of CB4M-S quad synchronous control box and DKP3 desk control panel is applied to
lifting desk. It is able to control and adjust the lifting desk to up and down and to work with
the model of FD60 actuator.
A. Install and Learning procedure:
1. Whe CB4M-S and DKP3 are connected and power on at the first time, the display of
DKP3 flashes “SEt”. Only learing procedure can be excuted now.
2. Learning: Hold buttons and together for 2 seconds, the display flashes “SEt”
and the 4 actuators start to run full stroke to record the positions of upper and lower
limits. The table will go down to the bottom and up to the top position. Then go down to
the bottom position again. After the learning procedure is finished, the display shows
still sign of “000” and it can be operated.
3. The unit has to run the full stroke learning procedure after reinstalled on the other table.
4. Pressing any buttons or unplugging the panel can stop table from learning procedure.
5. The unit will memorize the full stroke of the table after finishing the learning procedure.
If the power is cut off and reconnected, you may operate directly without Learning.
CB4M-S
DKP3

Summary

Install and Learning Procedure

Initial Power On and Learning Mode

On first power-up, the DKP3 display flashes 'SEt', indicating learning mode is active.

Performing the Learning Procedure

Hold specific buttons to initiate actuator movement, recording upper/lower limits.

Learning Procedure Requirements

Full stroke learning is required after reinstallation on a new table.

Stopping the Learning Process

Pressing any button or unplugging the panel stops the learning procedure.

Learning Procedure Memory

The unit memorizes the full stroke after learning; power cycles do not require re-learning.

General Operation

Moving Up

Press and hold the up button to move the table to the upper limit position 012.

Moving Down

Press and hold the down button to move the table to the bottom position 000.

Standby Mode

The display turns off automatically if no button is pressed for 20 seconds.

Memory Function

Saving a Position

Adjust height, hold buttons, then press a number button to save the position.

Saving Multiple Positions

Positions 2, 3, and 4 are memorized using the same procedure as position 1.

Memory Mode Timeout

Memory mode exits if no number button is pressed within 10 seconds after holding.

Recalling Saved Positions

Press and hold numbered buttons to move the table to the memorized position.

Protection Function

Overload Protection

Actuators stop automatically and display shows 'E01' on overload.

Reset Alignment

Hold the reset button to move the table down for alignment when display shows '000'.

MOTECK CB4M-S Specifications

General

Brand	MOTECK
Model	CB4M-S
Category	Control Unit
Language	English