Need help?Do you have a question about the Motinova CS520 Series and is the answer not in the manual?
Fixing the cycle computer controller to the left handlebar and adjusting its position and viewing angle.
Install screws with a suggested torque of 2-2.5 N.m to avoid damage from over-locking.
Shift up or down the gear level by short pressing the '+' or '-' buttons.
Enter the settings menu by long pressing the 'Setting' button for over 1.5 seconds.
Turn the light on or off by short pressing the 'Light' button.
Turn the device on by pressing the 'Power' button for 1s and off by short pressing it.
Engage walk mode for assistance up to 6 km/h, with specific button interactions detailed.
Cycle through continuable, current, and total trip data by short pressing the 'Setting' key.
Choose from 6 assist levels: OFF, ECO, NORM, SPORT, TURBO, and SMART.
The default assist level is OFF, providing no power output.
Adjust system time by selecting and confirming hour and minute values.
Select speed and mileage units (km or mile) and confirm the chosen setting.
Reset the subtotal mileage value; this operation is irrevocable.
Adjust backlight brightness from Level 1 to Level 5.
Configure automatic power-off time from 5 to 30 minutes in 5-minute increments.
The material of the product is plastic.
The device operates within a temperature range of -10°C to +50°C.
Supports 24V, 36V, or 48V systems.
Controller dimensions: 59 x 49 x 44 mm; Display dimensions: 82.5 x 21 x 70mm.
Compatible with handlebar diameters: controller $22.2mm; display $22.2mm, $25.4mm, $31.8mm.
The product has an IP55 ingress protection rating.
To Next Page
General