Motion CM-06 User Manual

3 s
13
14
MOTION BLINDS CM-06 LI-ION TUBULAR MOTOR
Remote control: Choose the channel to which the blind
has been paired using the channel button.
Direct control off : Shortly press the up or down button
to slightly tilt the blind. Hold the up or down for 2
seconds and the blind will move to the end position.
Press the center button to stop the blind.
Direct control on : The blind will move to the end
position by a single press on the up or down button.
Press the center button to stop the blind.
Center
Operate the blind
Operate to favourite position
Pull control: pull once to move the blind to the end
positions. Pull again to stop the blind.
Direct control off : The blind will tilt slowly and lift at normal
speed.
Direct control on : The blind will tilt and lift at normal speed.
Remote control: Hold the center button to move the
blind to the favourite position.
Pull control: Pull and hold to move the
blind to the favourite position.
Up
Down
Center
Channel
Selection
English
13

Motion CM-06 Specifications

General

Brand	Motion
Model	CM-06
Category	Engine
Language	English