18
18.1
+
2x
2x
MOTION BLINDS CM-06 LI-ION TUBULAR MOTOR
Hold the program button and pull twice to activate or deactivate the motor.
The motor can also be activated by charging it with a micro USB cable.
To prevent the blind from getting damaged, the motor has a transport
mode that makes sure the blind will not be activated before installation.
Activate / deactivate the motor
or
English
Frequently Asked Questions
Problem Cause Solution
Blind does not work.
Motor is in transport mode. Activate the motor. See step 18.
Motor battery is empty. Charge the motor. See step 17.
Remote battery is empty. (LEDS of remote
are flashing rapidly.)
Replace the battery in the remote.
See the manual of the remote.
Remote battery is inserted incorrectly.
Replace the battery in the remote.
See the manual of the remote.
Radio-frequency interference Make sure that the antenna of the motor is
out of the way of metal objects.
The distance from the remote/phone to the
motor is too far.
Move closer to the motor.
The remote is not connected to
the blind.
Pair the remote with the motor.
See step 5.
Motor LED flashes red. The battery of the motor is empty. Charge the motor. See step 17.
Blind is not charging.
Charger is not plugged in or does not work.
Try a different charger or make sure the
charger is plugged in the outlet.
Multiple blinds respond to a
remote. (Unable to program
a single blind)
Multiple blinds are paired with a single
channel.
Pair the blind with a free channel to
program or use single select to program
the blind.
Blind moves in small steps.
1) No end limits are programmed.
2) Direct control is deactivated.
1) Program end limits. See step 7 - 10.
2) Activate direct control. See step 16.
Favourite position can not
be programmed.
No end limits are programmed. Program end limits.
See step 7 - 10.
Blind lowers too far. End limits are programmed incorrectly. Reprogram end limits. See step 7 - 10.
Blind moves in the opposite
direction.
The rotational direction has been
set incorrectly.
Change the rotational direction.
See step 6.
The blind keeps moving up
and down.
The blind is in program mode.
Press the program button on the motor
to exit program mode.
Hold
17
To Next Page
Loading...
Need help?
General
