Need help?Do you have a question about the Motion CM-35 and is the answer not in the manual?
Features an alternating current motor for operation.
Powered by 120V/230V mains electricity.
High torque motorization and low noise operation.
Features bi-directional communication for real-time response.
Allows operation using a pull control mechanism.
Enables operation with remote controls.
Supports operation via the MOTION mobile application.
Compatible with home and building automation systems.
Provides guides on installation, programming, and operation.
Direct links for downloading the MOTION app from app stores.
Instructions for safe use, child safety, and cord hazards.
Guidelines for cleaning the device and its components.
Do not perform repairs; no user-serviceable parts inside.
Contact dealer for service if damaged or not functioning properly.
Instructions for responsible disposal and recycling of the product.
Reduce risk of severe injury or death by following instructions.
Age restrictions, supervision, and handling of controls.
Examine for wear, disconnect power for maintenance.
Specifically for indoor and household use only.
Motor use with soft material, moving part placement, manual release height.
Actuating member height, visibility, compatibility, fixed controls.
All-pole disconnection, safety extra low voltage, component removal.
FCC ID, emission notices, radio frequency interference statements.
Declaration of compliance with EU directive 2014/53/EU.
Visual guide to the controls and functions of the CM-11 remote.
Visual guide to the controls and functions of the CM-12 remote.
Visual guide to the controls and functions of the CM-13 remote.
Visual guide to the controls and functions of the CM-17 remote.
Visual guide to the controls and functions of the CM-15 remote.
Visual guide to the controls and functions of the CM-16 remote.
Visual guide to the controls and functions of the CM-18 remote.
Visual representation of the CM-20 Motion Bridge unit.
Step-by-step visual guide for installing the blind mechanism onto the track.
Diagram and table detailing mains cable connections for 230V/120V.
Detailed steps for pairing a remote control to the blind motor.
Instructions to verify and change the motor's direction of rotation.
Steps to define and save the blind's fully closed end position.
Steps to define and save the blind's fully open end position.
Procedures for setting and saving a preferred blind position.
Instructions for operating the blind using remote or pull controls.
How to command the blind to move to its previously saved favourite position.
Steps required to erase the stored favourite position.
Method for removing only the programmed end limits.
Instructions for a complete reset to original factory defaults.
How to manually control the blind directly from the motor unit.
Guide to pairing a single blind using a 5-channel remote.
Guide to pairing a single blind using a 15-channel remote.
Procedure for copying blind configurations between channels/remotes.
Procedure for copying blind configurations between channels/remotes.
A guide to resolving typical problems encountered with the blind.
To Next Page
General
