MotionBlinds CMD-02-P - Remote Control Direct Control; Deactivate Direct Control

5 s
.1
.2
20
Deactivate direct control for remote control
When pressing the up or down button on the remote control, the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be deactivated. Now, the blind only directly moves to its end
positions when the up or down button is held longer than two seconds.
Press the program button on the motor to activate program mode. The blind starts stepping.
Hold the program button until the blind stops stepping (approximately 5 seconds) to deactivate or
reactivate direct control.