Need help?Do you have a question about the MotionBlinds CMD-02-P and is the answer not in the manual?
Warnings regarding cord hazards and keeping cords away from children to prevent strangulation.
Guidelines for cleaning, service limitations, warranty claims, and environmental disposal.
Guidelines for safe operation, child safety, and maintenance procedures.
Specifications for motor installation, mounting height, and component compatibility.
Labels and identification of key buttons and ports on the motor unit.
Step-by-step guide for physically mounting the motorized blind.
Connect the blind to a power source to enable its operation.
Manually move the blind to the desired bottom limit and adjust.
Hold the button to store the set bottom limit for the blind.
Manually move the blind to the desired top limit and adjust.
Hold the button to store the set top limit for the blind.
Move the blind to a specific end position for fine-tuning.
Hold the button for 3 seconds to clear a saved end position.
Move the blind to the desired new bottom position.
Hold the button to store the newly set bottom position.
Position blind and hold pull for ~7s to save favorite position.
Hold pull for 5s to move blind to its favorite position.
Remove existing and set a new favorite position using the pull.
Press End Position button twice to reverse motor rotation direction.
Connect a MOTION Blinds remote to the blind motor.
Connect to a bridge for advanced features like voice control.
Connect to USB-C 5V for charging, indicated by LED status.
Hold reset/program button for 20s to clear positions and pairings.
Connect a MOTION Blinds remote to the blind motor.
Verify and adjust the motor's rotational direction.
Use the remote's down button to reach the bottom limit.
Hold centre and up buttons to save the set bottom position.
Use the remote's up button to reach the top limit.
Hold centre and down buttons to save the set top position.
Save a preferred blind position using the centre button.
Exit program mode by pressing the program button on the motor.
Disable direct movement for smaller steps by holding program button.
Enable or disable transport mode to prevent accidental operation before installation.
General| Model | CMD-02-P |
|---|---|
| Category | Window Blinds |
| Communication | Zigbee |
| Power Source | Battery |
| Compatibility | Amazon Alexa, Google Assistant |
| Material | Fabric |
| Control Method | App, Voice |
To Next Page