.1
+
2x
22
Activate / deactivate the motor (Transport mode)
Hold the program button and pull twice to activate or deactivate the motor. ( When the motor is
activated a green LED will light up, When the motor is deactivated a red LED will light up)
To prevent the blind from getting damaged, the motor has a transport mode that
makes sure the blind will not be activated before installation.
Problem Cause Solution
Blind does not work.
Motor is in transport mode. Activate the motor. See page 6/22.
Motor battery is empty. Charge the motor. See page 14.
Remote battery is empty. (LEDS of remote are
flashing rapidly.)
Replace the battery in the remote.
See the manual of the remote.
Remote battery is inserted incorrectly.
Replace the battery in the remote.
See the manual of the remote.
Radio-frequency interference Make sure that the antenna of the motor is out of
the way of metal objects.
The distance from the bridge/remote to
the motor is too far.
Move closer to the motor.
The remote is not connected to
the blind.
Pair the remote with the motor.
See page 13.
Motor LED flashes red. The battery of the motor is empty. Charge the motor. See page 14.
Blind is not charging. Charger is not plugged in or does not work.
Try a different charger or make sure the charger is
plugged in the outlet.
Multiple blinds respond to a
remote. (Unable to program a
single blind)
Multiple blinds are paired with a single channel.
Pair the blind with a free channel to program or use
single select to program the blind.
Blind moves in small steps.
1) No end limits are programmed.
2) Direct control is deactivated.
1) Program end limits. See page 7-8, 16-18.
2) Activate direct control. See page 120
Favourite position can not
be programmed.
No end limits are programmed. Program end limits.
See page 7-8, 16-18.
Blind lowers too far. End limits are programmed incorrectly. Reprogram end limits. See step 10, 16-17.
Blind moves in the opposite
direction.
The rotational direction has been
set incorrectly.
Change the rotational direction.
See page 12, 16.
The blind keeps moving up
and down.
The blind is in program mode.
Press the program button on the motor
to exit program mode.
To Next Page
Loading...