13. Setup (continued)
Use voice coaching options to enable/customize audio updates while recording a track.
• Turn voice coaching audio updates On/Off
• Turn Notifications On/Off (notifications appear when the track recorder is running
and the display is turned off)
• Choose whether you want a notification for lost GPS signal
Track Recorder
• Turn the Track Recorder “3,2,1, Go” countdown On/Off
• Choose Track Recorder metrics for which you want an update (elapsed time,
distance, speed/pace, elevation, heart rate)
Navigation
• Choose navigation update options (announced when actively navigating to a
waypoint), including distance, bearing, and time to waypoint
Settings
• Set the update trigger: choose either time or distance
• Select either current or average speed/pace and heart rate
• Adjust the Update Interval slider to increase or decrease the time between voice
coaching updates
• Control the sound level of voice coaching with the Voice Volume slider
• Turn on Pause iPod for Voice to pause/resume your music during voice coaching
updates. When the switch is Off, music volume will fade during updates.
Track your heart rate from MotionX using a ANT+ or Bluetooth Low Energy (BLE) chest
strap heart rate sensor.
ANT+
To setup an ANT+ heart rate monitor, wear the chest strap and connect the ANT+
receiver (dongle or case) to your iPhone. Select Manage Sensor>Connect. Once
connected, your heart rate will display on the setup page and in the track recorder.
US and Foreign Patents Granted and Pending. Fullpower®, MotionX®, TapTap®, and ShakeShake® are registered trademarks of Fullpower Technologies,
Inc.All other trademarks remain the property of their respective owners. © Copyright 2003-2013 Fullpower Technologies, Inc. All rights reserved.
!
To Next Page
Loading...