User Manual Rev 1.0 35
A. Appendix A – Specifications
This chapter lists the specifications for the MLC-1010 LCD monitor.
Display Characteristics
Viewable area: 4:3 aspect ratio. 210.4mm wide x 157.8mm high.
26.4cm (10.4-inch) diagonal.
Native Resolution: 1024 x 768. Dot pitch: 0.2055mm x 0. 2055mm.
Contrast ratio: 1200:1 typical. 900:1 minimum.
Colours: 24-bit (16,777,216).
Response time: Ton: 30ms typical (35ms max). Toff: 11ms typical (15ms max).
Brightness: 700 nits, typical. (This value applies to indoor performance. The
effective outdoor performance is greater than 1,000 nits. 1 nit = 1
Cd/m
2
.)
Viewing angle: Horizontal: 176° typ, 160° minimum.
Vertical: 176° typ, 160° minimum.
LCD Controller
Video input interface: VGA: Analog RGB, 0.7Vp-p. (DVI is available for OEM orders.)
Input resolutions: 640x480, 800x600, 1024x768 and 1280x1024.
The monitor automatically scales the input signal.
Input vertical frequency: 60Hz and 70Hz. 60Hz is recommended.
Configuration: On-Screen Display (OSD) includes: Brightness, Contrast Ratio,
H-position, V-position, Clock Phase and Colour Balance.
User Interface
Monitor controls: Front panel buttons are: Power On/Off, Backlight Brightness Up and
Down, OSD menu.
OSD menu controls: On Screen Display (OSD) menu control buttons are: Menu/Select,
Left and Right.
Audio
Speaker: Front panel mounted speaker, with internal fixed-gain amplifier. The
speaker is intended to connect to a PC, for operator feedback and
warning tones. This is a good quality speaker, not a low-cost piezo.
Microphone: Front panel mounted microphone, with internal pre-amplifier. (This
is an OEM option, and is not fitted as standard.) The microphone is
intended to connect to a PC, for audio recording or use in
emergencies.
Touch Screen
Touch Type: 5-wire resistive.
Glass thickness: 1.8mm.
Operation force: <1N with a stylus of 0.8mm radius.
Linearity: < 1.5% for both X-axis and Y-axis.
Chattering: < 10ms.
To Next Page