Need help?Do you have a question about the Motomaster Eliminator 011-1906-4 and is the answer not in the manual?
General| Engine Start | Yes |
|---|---|
| Installation | Professional installation recommended |
| Brand | Motomaster |
| Model | 011-1906-4 |
| Number of Remotes | 2 |
| Engine Stop | Yes |
| Trunk Release | Yes |
| Power Door Locks | Yes |
| Security System | Yes |
Indicates the charge level of the internal battery.
Illuminates Red if reverse polarity is detected, or blinks “On” and “Off” when the internal battery temperature is too high.
Push to turn unit “On” & “Off”.
Illuminates White when unit is “On”.
Illuminates White when the jump starter is active. If the unit is connected properly to a battery, the jump starter will automatically detect a battery and go into jump starting mode (LED flashes White when Manual Overide feature is active).
To enable, push and hold for three (3) seconds. WARNING: Disables safety protection and manually forces the jump starter “On”. Only for use when a battery is too low to be detected.
Toggles the ultra-bright LED light through 7 light modes: 100% > 50% > 10% > SOS > Blink > Strobe > Off
Details the time required to recharge the jump starter based on charger rating and discharge level.
Instructions on how to recharge external USB devices using the jump starter's USB Out port.
Explains the integrated ultra-bright LED flashlight and its seven light modes.
Describes the built-in feature that automatically powers off the unit after seven hours of inactivity.
To Next Page
