Motorola solutions APX 8000XE User Manual

APX 8000XE M2 AND M3
124
NEXT > < PREV CONTENTS
 Quick Call II (ASTRO P25 Digital Trunking and Conventional)
ADVANCED FEATURES
This feature allows the user to broadcast a series of distinct,
recognizable tones before a voice transmission from the
dispatcher or a radio.
The broadcasting dispatcher or radio user can select this alert
tone transmission to be sent to an individual Talkgroup or
over the entire system. Specific tone or series of tones are
pre-programmed into the radios to allow the dispatcher or
supervisor to select a list of tones to broadcast before they
make their voice transmission. Each tone is distinctive to
indicate different situation or different broadcaster. The
transmitting radio also plays back the tones for the
broadcaster to listen.
Note: The broadcasting or transmitting radio must be
preprogrammed to see the tone in the Quick Call II tone list.
The receiving radio must also be preprogrammed to decode
the tone to broadcast.
Initiating a Quick Call II Transmission
Procedure:
1. or to QCII.
2. Press the Menu Select button directly below QCII.
3. or to select the tone to broadcast.
4. Press the PTT to broadcast the selected tone, or press
and hold the PTT to broadcast the selected tone and
transmit with your vocal transmission.
You hear the radio sounds the selected tone.
You can begin your call after the tone ends.
Release PTT to listen.

Motorola solutions APX 8000XE Specifications

General

IP Rating	IP68
Operating Temperature	-30°C to +60°C
GPS	Yes
Bluetooth	Yes
Wi-Fi	Yes
P25 Phase 1 & 2	Yes
Frequency Range	700/800 MHz
Channel Capacity	1000
Display	Color display
Intrinsically Safe	Yes