APX 8000XE M2 AND M3
133
NEXT > < PREV CONTENTS
Fireground (Conventional Only)
Entering Fireground Zone Channel
ADVANCED FEATURES
Procedure:
1. Upon Powering Up
If the Fireground Zone Channel is set as default, you hear
gurgle tone and the home screen.
You are in Fireground zone channel.
OR
If the Fireground Zone Channel is set as default, but you
hear a short, low-pitched tone, the display shows Reg
failed to indicate that the command terminal does not
respond to Fireground Zone Channel.
Get qualified technician for assistance.
OR
Your home channel is not Fireground Zone Channel,
toggle or change the radio zone channel to Fireground
Zone Channel.
2. Listen for a transmission.
Adjust the Volume Control Knob if necessary.
3. Press and hold the preprogrammed Volume Set button
to hear the volume set tone.
Adjust the Volume Control Knob if necessary.
Release the Volume Set button.
OR
At the desired Fireground zone and channel, press the
preprogrammed Monitor button and listen for activity.
Adjust the Volume Control Knob if necessary.
OR
If your radio is working in Fireground Zone Channel,
proceed to next step.
4. Press and hold the PTT button to transmit.
The LED lights up solid RED while transmitting.
Talk into the microphone clearly if needed.
5. Release the PTT button to receive.
You hear a Transmit End Tone.
To Next Page
Loading...
