APX 8000XE M2 AND M3
134
NEXT > < PREV CONTENTS
Fireground (Conventional Only)
Responding to Evacuation Indicator
ADVANCED FEATURES
When Incident Commander triggers Evacuation signal from his command terminal, the RF Modem updates everyone in the
Fireground Communication System with the order to evacuate the incident site.
Procedure:
1. Your radio sounds the Evacuation Tone at the profile’s maximum alert tone volume level.
The display shows EVACUATE.
Moving the volume knob to adjust the volume of the Evacuation Tone from full volume.
OR
Perform any action on the radio other than volume adjustments to cancel the evacuation indications and update the
command terminal.
OR
If preprogrammed with Manual Acknowledgement of Evacuation Command, press the PTT button shall cancel the indications
and acknowledge the command terminal.
To Next Page
Loading...
