EasyManuals Logo

Motorola solutions APX 8000XE User Manual

Motorola solutions APX 8000XE
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
APX 8000XE M2 AND M3
35
NEXT > < PREV CONTENTS
Attaching/Removing the Accessory Connector Cover
PREPARING YOUR RADIO FOR USE
The accessory connector is located on the antenna side of the radio. It is used to
connect accessories to the radio.
Note: To prevent damage to the connector, shield it with the connector cover when
not in use.
Accessory Connector Cover must be fully secured to meet the salt water submersion
specification.
Slide the Accessory Connector Cover over the antenna and position
at the base of the antenna.
Insert the hooked end of the cover into the slot above the connector.
Press downward on the cover’s top to seat it in the slot.
Once in place, tighten by rotating the thumbscrew clockwise by
hand.
To remove the accessory connector cover, rotate the thumbscrew
counterclockwise until it disengages from the radio.
If the thumbscrew is too tight, use an Allen wrench to loosen
it first.
Rotate and lift the connector cover to disengage it from
the radio.
Accessory
Connector

Other manuals for Motorola solutions APX 8000XE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Motorola solutions APX 8000XE and is the answer not in the manual?

Motorola solutions APX 8000XE Specifications

General IconGeneral
BrandMotorola solutions
ModelAPX 8000XE
CategoryTwo-Way Radio
LanguageEnglish

Related product manuals