TRANSFER STATION II
Stand-alone
battery
Power and Link
LEDs
Slot LEDs Slot ID V300 Camera
FULL TRANSFER STATION II QUICK START GUIDE:
www.motorolasolutions.com/ets
Motorola Solutions Inc., 500 W Monroe St, Chicago, IL 60661. U.S.A. motorolasolutions.com MOTOROLA, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks
of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners. ©2023 Motorola Solutions, Inc. All rights reserved.
WGD00171
SETUP
1. Connect the ethernet cable to the ethernet connector on
the back of the Transfer Station II.
2. Connect the power cable to the power connector on the
bottom of the Transfer Station II and plug the power cable
into an electrical outlet.
3. Power the Transfer Station II ON using the switch on the
back. The serial number is located on the bottom.
4. Connect the other end of the ethernet cable to a
computer that you have set up to access the Transfer
Station II factory default configuration web page.
To Previous Page
Loading...
Need help?
General
