36 AP6522 Access Point
• Time Zone - Set the time zone where the access point is deployed. This is a required parameter. The
setting should be complimentary with the selected deployment country.
27. If an NTP resource is unavailable, set the System Date and Time (calendar date, time and AM/PM
designation).
28. Optionally enter the IP address of a server used to provide system time to the access point. Once the IP
address is entered, the Network Time Protocol (NTP) functionality is engaged automatically for
synchronization with the NTP resource.
29. If an NTP resource is unavailable, set the System Date and Time (calendar date, time and AM/PM
designation).
30. Optionally enter the IP address of a server used to provide system time to the access point. Once the IP
address is entered, the Network Time Protocol (NTP) functionality is engaged automatically for
synchronization with the NTP resource.
31. Select Next. The Initial AP Setup Wizard displays the Summary and Commit screen to summarize the
screens (pages) and settings updated using the Initial AP Setup Wizard.
There's no user intervention or additional settings required within this screen. It’s an additional means of
validating the configuration before its deployed. However, if a screen displays settings not intended as
part of the initial configuration, the screen can be selected from within the Navigation Panel and its
settings modified accordingly.
To Next Page
Loading...
Need help?
General
