Why are the LEDs not lit on my Motorola AP 7161 Wireless Access Point?
If the LEDs on your Motorola Wireless Access Point are not lit, it could be due to a few reasons. First, ensure that a compatible 802.3at power source is connected via PoE. Also, check the AC source to the PoE injector. It's also possible that the unit was configured with LEDs disabled.
Provides essential safety and installation procedures for the device.
Outlines the procedure for mounting the AP 7161 on poles.
Describes the process for securely mounting the AP 7161 on walls.
Covers essential safety guidelines for using wireless devices.
Provides information on complying with standards for human exposure to RF energy.
General| Model | AP 7161 |
|---|---|
| Type | Wireless Access Point |
| Frequency Bands | 2.4 GHz and 5 GHz |
| Wireless Standards | 802.11a/b/g/n |
| Maximum Data Rate | Up to 300 Mbps |
| MIMO Technology | 2x2 MIMO |
| Humidity | 5% to 95% non-condensing |
| PoE | Yes |
| Power over Ethernet | 802.3af |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -40°C to 70°C |
| Antenna | Internal |
| Security Features | WPA, WPA2, 802.1X |
To Next Page