Motorola C12 - Connecting the Base

7
Getting started
Connecting the base
1. Plug the telephone line cord into the socket marked on the underside
of the base.
2. Plug the power adaptor into the socket marked
on the underside of
the base and plug the other end into the mains power wall socket. Switch
on the mains power.
Installing and charging the handset
1. Remove the battery cover from the back of the handset and insert the
rechargeable Ni-MH battery cells supplied. Please note the ’+’ and
’-’ markings inside the battery compartment and insert in the correct
direction.
2. Slide the battery cover back into place.
3. If you are charging the batteries for the rst time, place the handset on
the base to charge for at least 24 hours continuously.
4. When the handset is fully charged,
icon will appear steady on the
display. Plug the other end of the telephone line cord (make sure that one
end is already plugged into the base) into the telephone wall socket.
Press
down
1
Slide
2