Level 1-2 Service Manual
July 5, 2005 19
5. (Optional) Remove and replace the rubber keypad. It slips out of the front housing.
Figure 11. Removing the rubber keypad
6. To replace, simply snap the front and back halves together again.
Removing and Replacing the Transceiver Board, Back Housing, and Vibrator
Module
1. Remove the front housing.
2. Remove two T5 screws securing the PCB transceiver board to the back housing (torque
force of 1.4 kgf-cm).
Figure 12. Removing two T5 screws (T-force = 1.4 kgf-cm)
To Next Page
Loading...
