3
2. Getting started
Connecting the base
1. Plug the telephone line cord into the socket marked on the underside of
the base and the other end of the line cord into the telephone line wall jack.
2. Plug the AC power jack into the socket marked
on the underside of the
base and plug the AC adaptor into the AC power outlet. Switch on the AC
power.
Installing and charging the handset
1. Remove the battery cover from the back of the handset by placing your
finger in the groove at the bottom of the handset and lifting the cover up
to release, insert the 2 x AAA Ni-MH rechargeable batteries supplied. Please
note the ’+’ and ’-’ markings inside the battery compartment and insert in
the correct direction.
Use your
finger to unclip
the cover and
lift up.
Insert your
finger
here.
Lower the
cover and
clip into
place.
Position the
battery
cover as
shown.
To close: To open:
1
2
To Next Page
Loading...
Need help?
General
