Motorola D1002 User Manual

8 Getting started
Connecting the base
1. Plug the telephone line cord into the socket marked on the underside of the base.
2. Plug the mains power cable with the clear connector into the socket marked on the
underside of the base and plug the other end into the mains power wall socket. Switch
on the mains power.
Installing and charging the handset
1. Remove the battery cover from the back of the handset and insert the rechargeable
Ni-MH battery cells supplied. Please note the ’+’ and ’-’ markings inside the battery
compartment and insert in the correct direction.
2. Slide the battery cover back into place.
3. If you are charging the batteries for the rst time, place the handset on the base to
charge for at least 24 hours continuously.
4. When the handset is fully charged, icon will appear steady on the display. Plug the
other end of the telephone line cord (make sure that one end is already plugged into
the base) into the telephone wall socket.
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for all the
handsets and chargers.

Motorola D1002 Specifications

General

Type	DECT telephone
Maximum indoor range	50 m
Maximum outdoor range	300 m
Speakerphone	Yes
Phonebook capacity	100 entries
Redial list capacity	10
Call list capacity phonebook	40
Volume control	Digital
Display number of lines	4 lines
Display number of colors	Monochrome
Frequency band	1.88/1.9 GHz
Camera included	No
Product color	Black
Standby time	100 h
Battery technology	Nickel-Metal Hydride (NiMH)
Number of batteries supported	2