Preparing Your Radio for Use
English
6
Attaching the Accessory Connector
The accessory connector is
to be secured to the
universal connector on the
antenna side of the radio.
To attach the accessory
connector,
1 Insert the slanted end
into the slots above the
universal connector.
2 Push connector upward.
3 Press downwards on
the accessory connector
until you hear a click.
To remove the accessory
connector,.
1 Pull the connector latch
outward.
2 Slide the connector
downward.
3 Pull the connector
outward.
Powering Up the Radio
Rotate the On/Off/Volume
Control Knob clockwise until
you hear a click. The LED
lights up solid green.
A brief tone sounds,
indicating that the power up
test is successful.There is no
power up tone if the radio
tones/alerts function is
disabled (see Turning Radio
Tones/Alerts On or Off on
page 46).
If your radio does not power
up, check your battery. Make
sure that it is charged and properly attached. If your radio still
does not power up, contact your dealer.
To turn off the radio, rotate this knob counterclockwise until you
hear a click.
To Next Page
Loading...
Need help?
General
