8
Getting started
Connecting the base
1. Plug the telephone line cord into the socket marked on the underside of
the base.
2. Plug the power adaptor into the socket marked
on the underside of the
base and plug the other end into the mains power wall socket. Switch on the
mains power.
Installing and charging the handset
1. Remove the battery cover from the back of the handset and insert the
rechargeable Ni-MH battery cells supplied. Please note the ’+’ and ’-’ markings
inside the battery compartment and insert in the correct direction.
2. Slide the battery cover back into place.
3. If you are charging the batteries for the first time, place the handset on the
base to charge for at least 16 hours continuously.
Press
down
1
Slide
2
To Next Page
Loading...
Need help?
General
