9
Getting started
4. When the handset is fully charged, icon will appear steady on the display.
Plug the other end of the telephone line cord (make sure that one end is
already plugged into the base) into the telephone wall socket.
Connecting the handset and charger (for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for
all the handsets and chargers.
1. Plug the power adaptor into the socket marked
on the underside of the
charger and plug the other end into the mains power wall socket.
2. Remove the battery cover from the back of the handset and insert the 2
x AAA Ni-MH rechargeable batteries supplied. Please note the ’+’ and ’-’
markings inside the battery compartment and insert in the correct direction.
3. Slide the battery cover back into place.
4. If you are charging the batteries for the first time, place the handset on the
charger to charge for at least 16 hours continuously.
5. When the handset is fully charged,
icon will appear steady on the display.
The display will show
HANDSET
and handset number (e.g. 2) to indicate that it
is registered to the base.
Important
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH
300mAh rechargeable batteries) supplied with your E2.
Battery low warning
If
icon flashes on the display and you hear a warning beep every minute during
a call, you will need to recharge the handset before you can use it again.
When charging,
icon will scroll on the display. Once charged scrolling will stop.
Battery performance
In ideal conditions, fully charged batteries should give up to 10 hours talk time or
up to 200 hours standby time on a single charge.
1
To Next Page
Loading...
Need help?
General
